Metallic Wax
Metallic Wax

Metallic Wax
29.90 €
29.90 €

Our metallic wax is ideal for reviving your dull floors, whether new or for your renovations. Self-shining and non-slip, it offers better resistance to abrasion and very effective protection against the attachment and penetration of dirt on thermoplastic floor coverings and tiles.

   Drying time: half an hour between each layer.

   Return to light traffic: 2 to 3 hours.

   Yield (two coats):
       •   porous support: 36 to 40 m² for 1 liter,
       •   non-porous support: 40 m² for 1 liter.

   Density = 1.03+/-0.01.

   Pure pH = 8+/-0.2.

   Preparation not subject to toxicity labeling according to European Directive No. 88/379 and its adaptations.

PROPERTIES:

   Concentrated emulsion with a high content of extra hard waxes.

   Contains metal ion resins.

   Very economical.

   Creation of an anti-slip and protective film.

   Exfoliation of micro-scratches on waxed concrete varnishes.

   Very high resistance to abrasion even on floors subject to intense traffic.

DESTINATION:

Tiled floors and thermoplastic coatings (cement tiles, terracotta, quartz screed after pore filler, linoleum, thermoplastic coating, tiles, stoneware, maintenance of waxed concrete after 1 or 2 years, marble).

RECOMMENDATIONS:

•   The support must not be alkaline, it must not be cleaned with degreasing products, bleach or dishwashing liquid with a pH greater than 9. The concrete support is also too alkaline. To remove the alkalinity of the support, clean with an acid product, followed by a good rinsing with water.

•   Oily carriers prevent wax from setting. Badly rinsed black soap leaves greasy surfaces. Use a degreasing cleaner followed by abundant rinsing. The supports must have a pH between 7 and 9. Above the wax does not adhere.

APPLICATION:

•   The first layer is to be diluted in water.

•   Simply apply with a mop in two crossed coats half an hour apart, and leave to dry without buffing. After drying, a resistant film provides protection against all common stains and brings shine to the floor covering.

•   Leave to dry for 2 to 3 hours before returning to light traffic.

•   Maintain regularly with a waxing shampoo.

Back to Concrete Treatment