Paint Stripper

Our paint stripper effectively removes all paints, stains and varnishes, even the most stubborn on all types of substrates. Paraffin-free and with a very low odour, it is ready to use. While competing products no longer work after a maximum of two hours, it remains active for up to 3 days.

   Application temperature: +5°C to +30°C.

   Consumption: 0.4 to 0.8 liters per m².

   Non-flammable, non-corrosive.

PROPERTIES:

   Without methylene chloride.

   Gel stripper, does not run even on vertical walls.

   Paraffin free, low odour, ready to use.

   Removes even stubborn layers.

   Active from 3 minutes of application up to 72 hours.

   Non-corrosive.

   Applicable in airless projection.

   Inside and outside.

   Deep stripping.

   Non-flammable.

   Does not darken the wood and does not attack the glass.

DESTINATION:

•   Intended for all types of media.

•   Eligible materials: single-component organic building paints, varnishes, thin films, plasters, thick and semi-thick plastic coatings, external thermal insulation, I3 and I4 waterproofing coatings.

RECOMMENDATIONS:

•   The support must be dry and perfectly cleaned. Scratch the paint beforehand if necessary, to facilitate the action of the stripper.

•   Wear goggles and gloves before handling.

TIPS:

•   Doing a test before application allows you to know exactly the time of action of the stripper on the surface to be stripped and thus optimize your time and effort.

•   On a surface of 20 cm², apply a thick layer then let the product react. Observe the stripper’s work. Make a partial scraping over time to compare the result.

APPLICATION:

•   Shake well before use. Apply a thick and regular layer which will guarantee an optimal result. Leave the stripper to act for 3 to 30 minutes, then remove the softened coating using a spatula, scraper or steel wool. Rinse with lukewarm water with a stiff brush.

•   The application of a new finish (paints, varnishes) is possible after 24 hours.