Facade Stripper

Our facade stripper effectively removes all paints, stains and varnishes, even the most stubborn ones on the facade. Paraffin-free and with a very low odour, it is ready to use. While competing products no longer work after a maximum of two hours, it remains active for up to 3 days.

   Application temperature: above +5°C.

   Yield: 0.4 to 0.8 liters per m².

   Non-flammable, non-corrosive.

PROPERTIES:

   Without methylene chloride.

   Gel stripper, does not run even on vertical walls.

   Paraffin free, odourless, ready to use.

   Removes even stubborn layers.

   Active for up to 72 hours.

   Non-corrosive.

   Applicable in airless projection.

   Inside and outside.

   Deep stripping.

   Non-flammable.

   Does not darken the wood and does not attack the glass.

DESTINATION:

•   Designed for all types of facades.

•   Eligible materials: single-component organic building paints, thin films, plasters, thick and semi-thick plastic coatings, external thermal insulation, I3 and I4 waterproofing coatings.

RECOMMENDATIONS:

•   The support must be dry and perfectly cleaned. Scratch the paint beforehand if necessary, to facilitate the action of the stripper.

TIPS:

•   Doing a test before application allows you to know exactly the time of action of the stripper on the surface to be stripped and thus optimize your time and effort.

•   On a surface of 20 cm², apply a thick layer then let the product react. Observe the stripper’s work. Make a partial scraping over time to compare the result.

APPLICATION:

•   Using a brush or any other airless spray equipment, apply a thick layer. Leave to act between 4 and 24 hours, or even up to 72 hours, depending on the nature of the coating and the load.
•   The action time may also vary depending on the temperature or wind conditions. To limit premature drying caused by the wind or high temperature, it can be covered with a plastic film.
•   Scrape with a spatula or a scraper then wash with hot or cold water, with a high pressure cleaner, minimum 120 bars, with a water flow rate of at least 800 liters per hour.